• Easy to assemble with double flange
• Cable material according to drinking water regulations (KTW approved)
• SAND FIGHTER™ SiC seal system for high performance in sand
• High efficiency electrical design for low operation cost
• All motors prefilled and 100% tested
• Maximum storage temperature -15 °C to +60 °C
• Designed for retrofitable Pt100 sensor
• Non contaminating FES93 filled design
• Standard Water Well Construction is cast iron end frames epoxy coated with 316SS stator

–  8″ double flange NEMA mounting design
–  Stainless steel splined shaft
–  Factory filled with Franklin’s FES93 motor fill solution for frost protection down to -15 °C storage temperature
–  Liquid lubricated radial bearings and High capacity Kingsbury type 45 kN thrust bearing  for 100 % maintenance free operation
–  Pressure-equalizing diaphragm, spring pre-loaded
–  SandFighter™ sealing system with SIC mechanical seal and sand slinger
–   High efficiency electrical design for low operation costs
–   Drinking water approvals

–  Ratings: 30 – 93 kW
–  Max. storage temperature – 15 °C to + 60 °C
–  Standard motor with PVC winding insulation
–  Nominal ambient temperature: 30 °C
with 0.2 m/s cooling flow for 30 – 52 kW motors
with 0.5 m/s cooling flow for 55 – 93 kW motors
–  Standard Voltage: 380 – 415 V (50 Hz), 460 V (60 Hz)
–  Voltage Tolerance: 50 Hz: -10 % / +6 % UN [380 – 415 V =
(380 – 10 %) – (415 + 6 %)], 60 Hz: ±10 % UN
–  Protection IP68
–  Motor protection: DIN 61947-4-1
–  Frequency of starts: 10 starts/ hour (with min. 3 minutes resting time), equally distributed
–  DOL / YΔ – start (pos. of cables 90 °)
–  Motor lead length: 6 m
–  Vertical and horizontal operation, shaft upwards (93 kW motors may not be installed in horizontal position)
–  Rotation counter clock wise facing shaft end (rotation reversible)
–  All motors with factory installed leads